ITL PRIME Specifications
	ITL PRIME	NHLA 1F & BTR
MINIMUM WIDTH AND LENGTHS	5" wide x 8' allowing 5% 5" x 7'. Cherry, Hard and Soft Maple admits 4" wide allowing 10% 4" x 7'. * The specifications do not apply for Walnut. Consult ITL representative for details.	4" wide x 6'
WANE LIMITATIONS	1/6 width x 1/3 length x 1/2 thickness -- generally limited to one edge only.	1/3 width x 1/2 length -- wane allowed to 1/2 length on both edges.
KNOT LIMITATION	Maximum 1/4 x surface measure -- open or unsightly knots are not permitted. Knots on the end foot of boards limited to one knot not exceeding 3/4" in diameter and on one end only.	Maximum 1/3 x surface measure -- no limit to the number of knots provided that no single knot exceeds 1/3 x surface measure. No restriction as to the location of the knots on the boards.
MINERAL LIMITATION	Excessive mineral is defected and sorted out. Casual streaks and spots are admitted.	Mineral not to exceed 1/12 the required cutting area. No limit on mineral outside the cutting area.
SPLIT LIMITATION	Limited to one split in each end provided their aggregate length does not exceed 8". Boards with surface measure of 9' and more, the split length is allowed up to one x surface measure provided there are 3" wide cuttings on both sides of the split.	All splits 12" and shorter are allowed. Splits longer than 12" are limited to 2 x surface measure.
1ST LINEAL FOOT	Generally allowed one defect on one end only (i.e., wane or one knot or one split).	No limit on the number of defects on either or both ends. Must be 50% clear and 25% sound 12" in from the ends.
SAP LIMITATION	No sapwood limitations except for hard maple which is 90% sapwood 1 face or better.	No sapwood limitations.

ITL wants to be your product-to-market partner.

Info Center | Environmental Statement and Forest Information

Locations | Products | Contact | Request Quote | Home